Canon ir2200 network kit serial number#
If a modified model and a part are no longer interchangeable, the serial number of copiers for which the part can be used is shown in this column. When there are differences in the specifications of power supply voltage, frequency, etc., the differences are described in words or indicated by one, two or three letters in front of the serial number. The Description column lists the description that should be used when ordering the part. The letters in this column indicate that the quantity of a part is not specified, allowing the use of the number of parts needed for assembly and that the quantity cannot be mentioned clearly.ĪR.quantity not specified or cannot be specified used in quantities as necessary at time of assmebly. However, the quantity listed for an assembly indicates the number of that assembly per machine. The quantity shown in this column is the number of parts used in the Figure. They are produced on a special-order basis. Parts marked "N" are service parts, but are not stock items. These Bulletins should be read carefully. Information regarding such changes will be provided by Service Information Bulletins. The Revision Number is changed if the part is modified. Note : The last three digits (suffix) of the Parts Number are called the Revision Number. The parts and assemblies identified as "NPN" do not have parts numbers or are not in stock, i.e., they are not available This Number must be used when ordering replacement parts. The second column shows the Part Number for the part. The first column shows the Figure Number of the illustration corresponding to the Parts List, and the Key Number that identifies the part on the illustration. The Parts List pages contain the following columns and information. Immediate shipping or action regarding the part depends on using its correct Part Number. Note : While looking for a Part Number, pay particular attention to the voltage listed in the SERIAL NUMBER/REMARKS column to ensure that the Part Number selected is for your type of machine. Refer to the Parts List on the page facing the exploded view and find the Key Number, Part Number and quantity required for your type of machine. Turn to the page(s), locate the part on the exploded view, and find its Key Number. Refer to the Assembly Location Diagrams and find the Figure Number of the assembly of interest. Below each box is the number of the Figure which shows an exploded view of the assembly.įinding a Parts Number. Their names are identified in rectangular boxes. These diagrams show the locations of major assemblies of the copier. POWER CORD TERMINAL ASSEMBLY(220/240V)Īssembly Location Diagrams. POWER CORD TERMINAL ASSEMBLY(100/120V)ġ11.
0 kommentar(er)
